There is no question about the wireless & IBM cabling which I memorized them for nothing.

1. You need to connect a WAN capable to transmit voice, data, and video simultaneously. Which of the following will you choose?

1. ISDN
2. Switch 56
3. T1
4. ATM

2. Which of the following is associated with ArcNet?

1. RG 58/U
2. RJ 45
3. RG 62
4. 22AWG

3. What is NDIS and ODI?

1. Enable the Network adapter card to work with any complaints
2. Allows ………
3. …..

I didn’t remember b, c, and d because they referred to something else. It didn’t mention anything about " it allows to bind multiple protocols to a NIC, or to bind a protocol to multiple NICs in a computer"

4. One segment of your 10Base2 network couldn’t access to the server. You use the Digital Volt Meter and you found: the terminator 50 ohms, the T-connector 0 ohms, the core 0 ohms, the core & the stranded shield 0 ohms. Give your suggestion:

1. Change the Network adapter card
2. Change the protocols due to mismatch protocols with the server
3. Reduce the packet size
4. Change the cable

5. One problem about the IRQ conflict. A user installed a sound card, then couldn’t access to the network, which IRQ is conflict? It’s an easy problem if you memorized 15 IRQ in the computer. I didn’t remember everything in this problem, but I remember it conflicted with IRQ 5

6. What associates with IEEE 802.3 of 10Base2?

7. One problem with the network, and you found two network adapter card with the same MAC address and a lot of other things.

8. Your network is utilized to 70% after you added 30 computers on the network…………………………You want to reduce the utilization down to 50%. Here is your network:

• Servers 5 WinNT, 1 IBM, 1 Unix
• 200 IBM PC
• 50 Macintos
• 100 Unix
• Protocols AppleTalk, NetBEUI, NWLink IPX, DLC,
• Bridge none
• Router none

Required: reduce the utilization to 50%

Optional: … ….

Propose: Reduce the amount of protocols and install the routers and the bridges

9. One problem with wanting to increase the performance of the busy network by reducing the packet size and increase the send TCP Window size.

10. Your network have a segment of RG 58A/U and RG 58 /U……….have problem….. What’s your suggestion11. What devices works at the packet size?

12. What can be changed with the telephone line……….basic rate……….?

13. After installed an adapter card & initialized correctly in a computer to access NetWare network. It couldn’t access the server, while other computers can.

14. What are routable protocols?

15. Network a WAN for three locations New York, Chicago, Los Angeles.

Required: 1Mbps, able to access if one link fail.
Propose: 2 T1

16. Same as #15, propose 3T1

17. User-level security & Shared-level security associate with different operating systems

18. Dial-up protocols of SLIP & PPP

19. What is the most common problem with the TCP/IP

20. What protocol router use to go from router to routers?

21. Two Implementation of a future giant network with very complexity of NetBIOS naming scheme. You have a lot of computers, servers, cables, and a long propose of all beautiful things on earth which I couldn’t understand. I wish I have some more time, then I’ll figure it out.

22. Which protocols disassemble the packet and assembler it?

23. Which of the following is best fit for UNC?

That’s all I remember so far at this time. I typed the wording in a sense that easy for me and you to understand. Be prepared to read the weir wording on the test.!!!!! Don’t panic, read careful, then you’ll see the answer.