Subject: This site will help you to get the perfect score.

Wow, I took the test and got the perfect score on the NT server exam. If you want to get a good result, I advise you to study the Transender test, exam cram, and brain dump. These will help you to get a good result, or if you want to get a perfect score, then pray to God before you take the exam as like I did. I am not going to post the questions because all the questions were same as the questions on this site.

Only three questions were new to me. So here are the quesitons.

Q. In mirro set disk, how do you make the fault tolerance boot disk when the primary hardisk failed?

1. Format a floppy disk with MS-DOS and copy Ntldr, NTdetect.com, ntbootdd.sys, and the boot,ini.

2. Format a floppy disk with windowsNT and copy Ntldr, NTdetect.com, ntbootdd.sys, and the boot,ini.

* This is was a little bit triky because the method to make the boot disk was right on both example, but the floppy disk should be formatted with windowsNT in order to access the NTFS file system. If the file system was FAT, then it wouldn't be matter though.

Q. How do you backup the registry files on the NT server?

1. Select the at least the one files of the registry files. * According to trandsender test, it would be wrong answer. However, I didn't have any choice other than the this choice. Then I got perfect score. (Maybe transender exam is wrong). DO check all the answers on this site's questions. Even the transender questions were wrong.

Q. You are a adminstrator on a network which has a three subnet. One subnet demand too much so it decrease the performance of the network. To improve this situation?

1. install another network card on server, and then divide the network in to physicaly subnet. then use the ip forward to connect the subnet.

Q. The video card didn't work on High resolution so install the new video card on server. How to ? (choose all the answers)

1. enter the space bar to enter the last know good config.

2. select the VGA mode when the computer starts.

3.chose the display on the control panel and choose the driver for the new video card.

4. ....

* Answers are turn out to be 2 and 3. I knew answer#3 is right,but I was doubting about answer#2. You must asume that new video card didn't work on the server at first time. So chose the VGA mode in order to log on system.

 For last note, you don't have to spend alot of money to pass the exam. but study the braindump then you will pass.